Ceramic Media Replacements | Ceramic Media Change-Outs
|
Ceramic Media Change Outs - Regenerative and
Regenerative Catalytic Oxidizers uses honeycomb
monolithic blocks. We take pride in that we
individually tile cut and hand place to fit
perfectly within the thermal oxidizer heat recovery
chamber or heat retention areas to reduce the
thermal oxidizers fuel costs. Monolithic blocks are a
reduce the time to achieve thermal destruction
time to achieve thermal destruction within the
within the combustion chamber. Hand
combustion chamber. Hand placement of the
placement of the ceramic media blocks assures
ceramic media blocks assures that no process
that no process air by pass or channeling air by
pass or channeling occurs reducing occurs
reducing destruction and increasing fuel
consumption.
Recovery Chamber (HRC). Located within this HRC area is the media bed, the media bed is used in the
the exhaust duct. Various types and sizes of bed media material are used depending on the VOCs and
Particulates in the waste streams. American Environmental Fabrication & Supply designs the
correct media for your process stream. By using the correct media bed material it will reduce the
possibility of plugging or any unwanted pressure drops across the regenerative thermal oxidizer system. It
is critical to the regenerative and catalytic thermal oxidizer system that proper bed quality, quantity,
style and design is used for proper VOC destruction, maintenance and air pollution control.
Monolith Structured Media offers the very best in Heat Recovery and Low Pressure Drop within the Heat
Recovery Chamber. For clean waste-gas streams where there is minimal fine particulates or gases where
no particulates are within the stream Ceramic Honeycomb Structured Media is the preferred choice.
We offer the following sizes and materials:
25 Cell - 32 Cell - 40 Cell - 50 Cell per sq.in.
High and Low Density Cordierite or Mullite
We offer services to repair and replace ceramic structured media on all regenerative and catalytic
thermal oxidizers. We use the same high quality materials and service. Each ceramic media block is
hand placed with any open areas filled with cut ceramic media, we do not fill gaps with saddles or
ceramic fiber insulation! This assures that the ceramic heat recovery bed is balanced without any
possible air channelling that may reduce your destruction efficiency. Competitively priced, for more
information call Scott Manes +1 918 708-1253 Ext. 4001.

American Environmental Fabrication & Supply LLC Fax: +1 (918) 772-3536
18991 S 410 Road Hulbert, OK 74441-1861 info@american-environmental.us
© 2010 All Rights Reserved. Visit our sitemap page for more information or contact the Webmaster.
Air Pollution Control Equipment
American Environmental Fabrication & Supply, LLC
Worldwide Shipping
Call +1 (918) 708 - 1253