Emission Control
American Environmental
Fabrication & Supply, LLC
Natural Gas Conditioning
Gas Separation Systems
VOC Biofiltration Systems
Granulated Carbon Systems
VOC Concentrators
Automated PLC Controls
Equipment Inspections - Installation - Rebuilds
Low NOx Burners
PSA Systems
a
Benefits of Renting vs. Owning Air Pollution Control Equipment
We have a ready to use air pollution control fleet or can design a specialized system for your plant operations. Some of the available systems include:
Granulated Activated Carbon (GAC) Systems, Biological Oxidation Systems, Wet Scrubbers, Regenerative, Catalytic and Direct Fired
Thermal Oxidizers
. Rentals range from 6 months to 5 years with flexible options.
Ceramic Media Replacement
Ceramic Media Change Outs - Regenerative and Regenerative Catalytic Oxidizers uses structured
honeycomb, ceramic balls and saddles. Newer ceramic media in the form of structured monolithic
blocks are now the preferred heat sink. This newer media can act as a replacement or addition to the
heat sink material reduces the auxiliary fuel requirement.

Ceramic saddles reduces the amount of potential plugging which may occur due to particulate matter
over extended operations. Should the process require ceramic saddles, different sizes may be used to
effect the heat recovery.

Should your process gases allow for the use of structured honeycomb ceramic media, it will be
important that the structured ceramic media be placed in such a way that air channeling around the
structured ceramic media bed doesn't occur. Channeling reduces the overall system thermal
efficiency and increases operational costs.

American Environmental Fabrication and Supply (AEFS) will individually cut the structured ceramic
media blocks and hand place each honeycomb monolithic block to fit perfectly within the heat
recovery chamber to reduce fuel costs and emissions. Monolithic blocks create the best laminar
process flows while offering the highest thermal efficiency. By replacing ceramic saddles with
honeycomb monolithic blocks a large reduction in fuel consumption may be achieved making
honeycomb media the preferred choice for most operations.

Should you need to increase process flows monolithic structured ceramic media will offer the very best
solution for lowing system pressure drop while increasing process flows through the heat recovery
chamber. Honeycomb structured ceramic media is the preferred  choice with clean waste-gas streams
with minimal particulate matter.

or increase in unwanted pressure drops will occur. AEFS will design, sell and or install the correct
media for your process stream or simply replace the same product if it is preferred.

We offer repair services on all regenerative thermal oxidizers. When installing structured ceramic
media, each honeycomb block is hand placed with any open areas filled with cut honeycomb ceramic
media block,
we do not fill gaps with saddles or ceramic fiber insulation!  

With AEFS, you get more than a supplier. You will also receive years of experience in the
development of high temperature solutions for the most demanding industrial, fire protection and
emission control applications.
35K RTO Ceramic Media Replacement
RTO Ceramic Media Replacement 35k RTO
Insulation Examination and Repair
Toll Free: +1 (866) 467 - 9374
Main: +1 (918) 708-1253
© 2009 All Rights Reserved.   Visit our sitemap page for more information or contact the Webmaster.
Our working process
in 3 steps





planing & strategy





test & deliver





design & develop
Implement proven equipment designs with
chemical, thermal and biological reactions
that achieves the required process result.
Results shall be based on reaction rates
and proper control logic.


a
American Environmental Fabrication & Supply Logo
Products
Product Inquiry
Purchase Plans
Services


a
Treatment Information
Helpful Equipment Information
Helpful Links
Our Corporate goal is to implement the
correct design criteria with the use of
proper metals, instruments and controls to
achieve the required result with the least
amount of maintenance and associated
energy costs.
We pride ourselves in going the extra mile
before it leaves the plant. It is our way of
knowing that you are receiving correctly
designed equipment to meet your specific
needs.